NELSON
™
HEAT TRACING SYSTEMS
INSTALLATION
PLT-BC
STANDARD POWER CONNECTION KIT
INSTRUCTIONS
SEALING GROMMET INSTALLATION FOR BRAIDED “CB” PRODUCTS
13mm (.5")
Slide braid back over heater cable and twist excess
braid into a pigtail.
Slide braid back, allowing at least 13mm (.5”) of
heater cable exposed.
Slide the sealing grommet over the heater cable and
position inside stand-off opening.
Cut and remove the exposed heater cable.
Continue with step 5 on sheet 2.
BRAIDED “CB” PRODUCTS
127mm (.5")
Bend heater cable and work it through the braid
opening.
114mm (4.5")
Secure heater cable braid with fiberglass tape,
allowing 127mm (5”) of cable for stripping.
Slide braid back towards the fiberglass tape creating
a bulge.
At the bulge, separate the braid to make an opening.
Pull the braid tight.
Proceed to “
LT, CLT & HLT Products”
on sheet 5.
P.O. BOX 726 TULSA, OK 74101 TEL 918-627-5530 FAX 918-641-7336 www.nelsonheaters.com
GA-1859 Rev. 6
Sheet 3 of 8
October 2006
