NELSON
™
HEAT TRACING SYSTEMS
INSTALLATION
PLT-BC
STANDARD POWER CONNECTION KIT
INSTRUCTIONS
FOR ALL NELSON LT, CLT & HLT PRODUCTS
(See sheet 6 for an alternate stripping method for HLT products.)
102mm (4")
Lightly cut around cable outer jacket 102mm (4")
from the end. Bend cable to break outer jacket.
Starting at the end, pull each bus wire away from
the core material.
Lightly cut the outer jacket up the center between
the first cut mark & the cable end. Bend cable to
break outer jacket.
Remove exposed core material.
Cut 6mm (0.25") off the end of each bus wire.
Proceed to
“Power Termination”
on sheet 7.
Remove the jacket from the heater cable.
P.O. BOX 726 TULSA, OK 74101 TEL 918-627-5530 FAX 918-641-7336 www.nelsonheaters.com
GA-1859 Rev. 6
Sheet 5 of 8
October 2006
!
DO NOT CUT BUS WIRES
WARNING:
Shave the core material from the outside of each
bus wire.
