Nelson EZ Pro Jr, Installation And Programming Manual

Page: 11 / 169

PROGRAMMING INSTRUCTIONS
Programming Overview
The EZ Pro ™ Jr. can be programmed under AC power or powered from the two
AA alkaline batteries. Before programming the EZ Pro ™ Jr., it may be helpful to
become familiar with some general programming guidelines:
• If a segment(s) on the LCD is flashing, it means that it can be changed by
the user.
• When using keys, hold the button three seconds to start a fast scroll.
• Be sure the appropriate program letter is displayed when you are
programming; program changes are specific to the program letter
displayed on the LCD.
• There is no “ENTER” key. Key-presses and dial settings are stored
automatically for you.
• If you make a programming change while a program is running, the
program terminates immediately. The new program starts at the next start
time scheduled.
• When not running, the controller displays the current time and the current day.
• During manual operations, there is a 5-second delay before the operation
begins. During this time, you can change your settings. Each time you
make a change, the delay resets to 5 seconds.
• MANUAL and CYCLE procedures only operate with the Program dial set in
the AUTO position.
• After a test procedure runs, the controller reverts back to the AUTO
procedure and runs the next program scheduled.
• The test procedures ignore the sensor connection; this allows you to
water or run your program even if the sensor has suspended operation.
• To clear all programs and start over, press and hold SELECT ‘–’ and
ADJUST ‘–’ for three seconds
11