when working near corners, sharp edges, etc. Prevent the cutting disc from
jumping and being jammed. When working corners or edges, there is an
increased risk of the disc jam, leading to a loss of control over the tool or its
kickback. Do not use cutting chain blades or circular saws. The blades cause
frequent kickbacks and the loss of control of the tool.
Warnings related to cutting with cutting disc
Use only tool specific cutting disc and guards that are designed for the type of
the grinding wheel in question. The cutting disc for which the tool is not designed
cannot be properly guarded and are not safe. The guard must be securely
attached to the tool and positioned for maximum safety so that the smallest
possible area of the disc is exposed towards the operator. This guard helps to
protect the operator from broken wheel fragments and prevents accidental
contact with the cutting disc.
The cutting disc must be used as intended. For example, do not sand with a
cutting disc. Cutting disc are designed for use under heavy pressure and the
lateral forces applied to them may cause them to fall apart. Always use
undamaged fixing flanges that are the correct size for the cutting disc. The
correct fixing flanges reduce the risk of damage to the grinding wheel. The fixing
flanges for cutting disc can be different from the fixing flanges for cutting disc.
3. TECHNICAL DESCRIPTION
1. Handle
2. Trigger
3. Air inlet
4. Exhaust
5. Adjustable air regulator
6. Guard
7. Cutting disc
