![background image](http://html1.mh-extra.com/html/neilsen/ct3324/ct3324_instruction-manual_3898043006.webp)
6
7. Disassemble the four nuts M8. See the diagram 8.
8. Assemble the joint linking sleeve and fasten the nuts
。
See the diagram 9.
9. Disassemble the two nutsM8. See the diagram 10.
10. Give two lock pressure plates of handrail a 180-degree change. See the diagram 11.
11. The first thing is to push down the height control hand lever and then assemble the handrail, with stop pin
stuck in the slot of handrail. (It is better to put the stop pin in the middle of slot.) See the diagram 12.
12. Pull lock pressure plates a 180 to bear on handrail and screw nuts. See the diagram 13.
13. When screw the four nuts of the lock pressure plate of handrail, take care of two following points:
●
When fastening the four nuts, the distance which nuts are screwed into is required the same.
●
When fastening the four nuts, It is required to push down the height control hand lever, and the handrail
can turn but not shake.
Diagram 7
Diagram 6
Worm wheel end face
Spoke end face
Diagram 8
Nut
M8
Diagram 9
Accessories’ connector bush
Diagram 10
Nut
M8
Diagram 11
Lock pressure plate of handrail