INSTALLATION INSTRUCTIONS FOR
LED
EMERGENCY UNIT
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION
WARNING:
RISK OF ELECTRIC SHOCK- NEVER CONNECT TO, DISCONNECT FROM, OR SERVICE WHILE EQUIPMENT IS
ENERGIZED.
WARNING:
FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH, SERIOUS INJURY
OR SIGNIFICANT PROPERTY DAMAGE - For your protec
ti
on, read and follow these warnings and instruc
ti
ons
carefully before installing or maintaining this equipment. These instruc
ti
ons do not a
tt
empt to cover all installa
ti
on
and maintenance situa
ti
ons.
•
All service shall be performed by quali
fi
ed service electrician. This product must be installed and maintained in
accordance with the applicable installa
ti
on codes by a person familiar with the construc
ti
on & opera
ti
on of the
product and the hazards involved.
•
This product must be installed in accordance with the applicable installa
ti
on
codes
and ordinances.
•
Before wiring to power supply, turn o
ff
electricity at fuse or circuit break
er.
•
Disconnect A. C. power and unplug ba
tt
ery before servicing.
•
Consult your local building code for approved wiring and installa
ti
on.
•
Do not let power supply cord touch hot surfaces.
•
Do not mount near gas or electric heater.
•
Equipment should be mounted in loca
ti
ons and at heights where it will not
readily be subjected to tampering by
unauthorized personnel.
•
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condi
ti
on.
•
Do not use this equipment for other than intended use.
•
Connect to an AC voltage as recommended on the product label of this equipment.
INSTALLATION INSTRUCTIONS
IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS!
W
IRING DIAGRAM
:
CAUTION
:
DO NOT connect YELLOW
and BLUE remote leads together. Please
also ensure remote head positive (+)
lead is connected to
Emergency u
nit's
yellow lead (+) and remote head
negative (-) lead is connected to
Emergency
unit's blue lead (-).
LAMP
LAMP
LED indicator
TEST
BATTERY
RED
BLACK
RED
BLACK
WHITE
277V
120V
0V
CHARGER
BOARD
JP1
For RC-SDT Only
For RC Only
BLUE(-)
BLUE(-)
BLUE(-)
)
)
)
TO REMOTE
Note:
Use 18-22 AWG stranded wire to
connect remote lamp heads.
Remove Jumper (JP1) from PCBA, if
remote lamps are being connected
(
RC-
SDT models only)
Unused input lead must be
properly insulated with wire nut or
other approved method.
Series
EM
T
RP
Legion Lighting Co., Inc.
|
221 Glenmore Avenue
,
Brooklyn, NY 11207
|
Phone: 718-498-1770
|
Fax:
718-498-0128
|
Toll Free: 1-800-4-LEGION
|
email: [email protected]
|
www.legionlighting.com
