19
Variable speed control
Simply apply light pressure to trigger to start the impact driver on a slow
speed. Increasing the pressuer on the switch will increase the speed of the
impact driver.
Note: You might hear a high pitched noise from the during use. Do not be
concerned; this is normal part of the switch function.
Forward & reverse switch
This feature is selected via a alide switch located above the trigger, To select
direction of the impact driver rotation simply push the botton fully in on the left
side for reverse rotation. To change to forward rotation push the button fully
on the right side of the handle.
NOTE: As a safety precaution from accidental engagment while being carried
pushing the forward/reverse button inton the middle or neutral position will
render the dirver inoperative.
Caution: To prevent gerar damage, always allow the chuck to come to a
complete stop before changing the direction of rotation.
NOTE: the dirver will not run unless the driection of rotation selector is pushed
fully to the left or right.
Avoid running the dirver at low speeds for extended preriods of time. Running
at low speeds under constant usage may cause the drill to become
overheated. If this occurs, cool the drill by running it without a load at full
speed.
Buit-in coupler
The tool has a built-in coupler. The coupler has benn designed to accpet 1/4
in. hex bits.
Installing bits
Lock switch trigger on the tool by placing the direction of rotation selectror in
center position.
Slide the coupler forward and hold position.
Insert bits straight into cuopler.
Slide the coupler back slowly and release.
Removing bits
Lock switch trigger or the drill by placing the direction of rotation seletor in
center position.
Slide the cuopler forward and hold position.