20
Pull bit straight out the coupler.
WARNING: Make sure the bits is secured in the coupler before using the
impact driver. Failure to do so could cause serious personal injury.
WARNING: Do not drive a screw where there is likely to be hidden wiring
behind the surface. Contact with a live wire will make exposed metal parts of
the tool live and shock the operator. If you must drive a screw where hidden
wire may be present, always hold tool by insulated gripping sufaces(handle)
when performing the operation to prevent a shock to the operator.
CAUTION: The impact driver is not designned to be use as drill.
INSTALLING THE BELT CLIP
Before fitting the belt clip set the forward/reverse button to the centre position
or turn tool off and disconnect battery pack.
To reduce the risk of serious personal injury, do not suspend tool overhead or
suspend objects from the belt hook. Only hang the tool’s belt clip from a work
belt.
When attaching or replacing the belt clip, use only the screw that is provided.
Be sure to securely tighten the screw with a Phillips screwdriver.
The belt clip can be attached to either side of the tool using only the screw
provided, to accommodate left or right handed users.
To move belt clip, remove the screw that holds the belt clip in place then
reassemble on the opposite side. Be sure to securely tighten screw.
Driving or removing screws
Place the direction of rotation selector in the correct position for the operation.
Hold the impact dirver with one hand.
Place the bit on the screw head and slowly depress the switch trigger. Start
the bit slowly for more control.
As the screw is driven, impacting will begin.
MAINTENANCE
This power tool normally requires no maintenance from time to time the
ventilation slots on the motor casing should be cleaned out. If the unit should
become defective, repair should be performed by an authorized service agent