![background image](http://html1.mh-extra.com/html/neilsen/ct1709/ct1709_original-instruction_3916666012.webp)
a scrub brush.
Application Of Wax
1. Immediately after cleaning, apply wax. Place injection tube in container of wax.
2. Apply the wax sparingly in an even layer. Apply to wet surfaces from bottom up
for even distribution and to avoid streaking.
3. Remove the suction tube from the wax bottle rinse off the surplus wax.
NOTE: IF SURPLUS WAX IS NOT REMOVED,A HAZYFINISH MAY RESULT.
4. Wipe dry to reduce water spotting.
END OF OPERATION
When you have completed use of the chemical injection system, remove tube
from container.Continue to run in low pressure position and inject clean water
through the tube and injection system by placing end of tube in a container of
clean water. Continue to run until it is thoroughly cleaned.
6. MAINTENANCE
CONNECTIONS
Connection on pressure washer hoses, gun and spray wand should be cleaned
regularly and lubricated with the manufacturer's recommended grease to prevent
leakage and damage to the o-rings.
NOZZLE
Clogging of the nozzle causes the pump pressure to be too high and cleaning is
immediately required.
WARNING! A nozzle cleaner must only be used when the spray wand is
disconnected from the gun or personal injury could be occur.
1. Separate the wand from the gun.
2.Clear the nozzle with a small rigid piece of wire such as a paper clip.
3.Flush the nozzle backwards with water.
4.Reconnect the wand to the gun.
Restart the pressure washer and depress the trigger on the spray gun. If the
nozzle is still plugged or partially plugged, repeat above instructions 1-4.
If the previous procedure does not clear the nozzle, replace with a new nozzle.
WATER SCREEN
The pressure washer is equipped with a water inlet screen to protect the pump.If
the screen is not kept clean,it will restrict the flow of water to the pressure
washer and may cause damage to the pump.Do not damage the screen while
removing or cleaning screen.Any foreign particles entering the pump may
damage the pump.Do not operate pressure washer without the screen