OPERATING CONNECTIONS
High Pressure Hose
Attach the high pressure hose to the pressure washer by pulling back the collar
on the quick connect coupling on the hose and pushing it over the coupling half
on the pressure washer outlet.
NOTE: DO NOT use a high pressure hose from another manufacturer.
Water Connection
Before connecting to unit, run water through the garden hose (not supplied) to
flush out any foreign matter.
Attach garden hose to the pressure washer water inlet.
NOTE:The water supply mush provide a minimum of 4 g.p.m. at 20p.s.i. or the
pump may be damaged.
OPERATING INSTRUCTIONS
Start-Up Procedure
1.Make sure water supply is connected and turned on.
2.Release gun safety if locked.
3.To allow air to escape from the hose, squeeze trigger on the gun until there is a
steady flow of water coming from the nozzle.
4.Remove any dirt or foreign matter from the gun outlet and the male connector
of the wand.
5.Insert the nozzle wand into the gun wand and tighten the twist fast fitting
securely by hand.
WARNING: If the wand is not securely locked into place, it
could be ejected under high pressure when operating the gun
,
possibly causing injury or damage.
Starting Engine
1) Check oil and gas
2)Connect hose & turn on water
3) Squeeze trigger
4) Make sure pressure washer is on the on position
5) Set gas lever to open
6) Set choke if available & set throttle to fast
7) When starting engine, pull cord slowly until resistance is felt, & then pull
rapidly to avoid kickback
8) If engine starts & fails to continue to run or if increase resistance is felt during
starting pull attempts repeat steps 3