CHEMICAL INJECTION
CAUTION! This pressure washer is intended for use only with liquid car wash
Detergents, developed specifically for pressure washer and with mild soaps.
Only use chemicals compatible with the aluminum and brass parts of the
pressure washer. Powdered soaps may clog the injection system. Always use
chemicals according to the manufacturer directions.We assumes no
responsibility for any damages caused by chemicals injected through this
pressure washer.
1. Attach injection tube assembly to the siphon injector on the pump.
2. Open a container of chemicals and place next to the unit near the injection
tube.
3. Visually inspect strainer at the end of the injection tube to verify that it is not
clogged.
4. Insert the injection tube into the container all the way to the bottom.
5. Remove the high pressure nozzle from the wand and install the black injection
nozzle. The solution will automatically mix with the water and discharge through
the nozzle.
NOTE: For certain models, if the engine throttle is not in the fast position, the
injection of the solution may be decreased or stopped.
CLEANING TECHNIQUES
When cleaning with the pressure washer,many cleaning tasks can be solved with
water alone, but for most tasks, it is advantageous to use a detergent also. A
detergent ensures a quick soaking of the dirt allowing the high pressure water to
penetrate and remove the dirt more effectively.
Application Of Soap Or Degreaser
1. Apply the solution to a DRY work surface.
On a vertical surface, apply horizontally from side to side starting from the bottom
to avoid streaking.
NOTE: Wetting the surface first is not recommended, it dilutes the detergent and
reduces its cleaning effects.
Avoid working on hot surfaces or in direct sunlight to minimize the chances of the
chemical damaging painted surfaces. Damage may occur to painted surface if
chemical is allowed to dry on the surface. Hold nozzle far enough away from
surface to prevent damage to the surface.
2. Allow chemical to remain on the surface for a short time before rinsing.
3. Rinse with clean water under high pressure.On a vertical surface, first rinse
from the bottom up,then rinse from the top down. Hold nozzle 6 to 8inches from
the work surface at a 45 ° angle using the flat spray as a peeling tool rather than
