Neilsen BDE2200E, Original Instructions Manual

Page: 11 / 44

Operation
Important! You must fill up with engine oil (approx. 0.6 l) and fuel before you can start the
engine.
Check the fuel level and top it up if necessary
Make sure that the generator has sufficient ventilation
Make sure that the ignition cable is secured to the spark plug
Inspect the immediate vicinity of the generator
Disconnect any electrical equipment which may already be connected to the generator
1. Starting the engine
Open the diesel cock by turning it down
Move the ON/OFF switch to position "ON” with the key.
Move the choke lever to position IØI.
Start the engine with the reversing starter by pulling the handle forcefully. If the engine does not
start, pull the handle again.
Push the choke lever back again after the engine has started.
Important!
When starting with the reserve starter, the motor may recoil suddenly as it starts up, resulting in
hand injuries. Wear protective gloves when starting the equipment.
2. Connecting consumers to the generator
Connect the equipment you want to use to the 230 V and 115V~sockets (3)
Important: These sockets may be loaded continuously (S1) with 2600W and temporarily (S2)
for a maximum of 2 minutes with 2800W.
The generator is suitable for 230 V and 115V~ AC appliances.
Do not connect the generator to the domestic power network as this may result in damage to
the generator itself or to other electrical appliances in your home.
Note: Some electrical appliances (power jigsaws, drills, etc.) may have a higher level of power
consumption when used in difficult conditions.
3. Switching off the engine
Before you switch off the generator, allow it to run briefly with no consumers so that it can "cool
down”
Move the ON/OFF switch to position "OFF” with the key.
Close the diesel cock