NEFF C67M70S0GB - annexe 2, Manual

Page: 17 / 40

17
■
Do not use any sharp or abrasive agents. The glass scraper
is not suitable.
Refitting
1.
Insert the door panel into the guide with both hands. (Fig. A).
2.
Push the door panel downwards, lift it slightly and hook it in
at the top. (Fig. B).
Make sure that the door panel is sitting flush with the control
panel.
3.
Fully open the door, while holding the panels firmly with one
hand. (Fig. C).
4.
Push the door downwards again and tighten the screws
hand-tight using a flat-bladed screwdriver (blade width 8-
11 mm), close the door. (Fig. D).
Caution!
You must not use the oven again until the panels have been
properly refitted.
Faults and repairs
It is not always necessary to call the after-sales service.
Sometimes, you can find a remedy yourself. You will find some
tips for troubleshooting in the following table.
ã=
Risk of electric shock!
■
Work on the appliance electronics may only be performed by
a specialist.
■
Always disconnect the appliance from the power supply
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
Malfunction table
If a meal doesn't turn out as well as you had hoped, refer to the
section Tested for you in our cooking studio , where you will
find plenty of cooking tips and tricks.
$ %
& '
Problem Possible cause Remedy/information
The appliance does not work. The plug is not plugged into the mains. Plug in the plug.
Power cut Check whether the kitchen light works.
Defective fuse Look in the fuse box to make sure that the
fuse for the appliance is OK.
Malfunction. Switch off the circuit-breaker for the
appliance in the fuse box, then switch it
back on after approximately 10 seconds.
The two dots and three zeros flash in
the display.
Power cut Reset the clock.
The microwave does not switch on. The door was not fully closed. Check whether food remains or foreign
material is trapped in the door.
The
ƒ
button has not been pressed. Press the
ƒ
button.
The appliance does not heat up to the
temperature which has been set.
The
ƒ
button was not pressed. Press the
ƒ
button.