![background image](http://html1.mh-extra.com/html/nectre-fireplaces/wonderfire/wonderfire_installation-and-operating-manual_3814058010.webp)
10
SYSTEM DESCRIPTION
RECEIVER
The Proflame Receiver (Fig. 3) connects directly to the gas valve and stepper motor with a
wiring harness. The Receiver is powered by 4 AA type batteries. The receiver accepts
commands via radio frequency from the transmitter to operate the appliance in accordance
with the particular Proflame system configuration. The receiver three position slider switch
can be set to one of three positions. ON (Manual Override), Remote (Remote Control) or Off.
Fig.3: Proflame Receiver body.
INSTALLATION
Hearth Mounting
1. Connect the wiring harness to the back of the Receiver.
2. Install the 4 AA type batteries in the battery compartment with the correct polarity.
3. Make sure the receiver and cover plate words “ON” and “UP” are on the same side.
4. Place the slider into the cover plate.
5. Align the slider with the switch on the receiver and couple the switch into the slider.
6. Using the two screws provided, secure the cover plate to the receiver.
AC/DC Power Pack
Your Nectre Wonderfire comes with a AC switch mode power pack which is required to be
plugged into a separate 10amp 240VAC outlet.
Output = 7.5V DC 600Ma
Input = 100-240V ac 50/60Hz
Short circuit and overload protection
Batteries are required in the receiver model for the Nectre Wonderfire to operate.
It is recommended that the batteries in both the remote and receiver are replaced at the
beginning of each new winter season to ensure safe and reliable operation of your Nectre
Wonderfire.
NOTE:
The Nectre Wonderfire has been manufactured to operate on batteries only when there is a
power failure. Battery life will be significantly reduced.
Summary of Contents for WONDERFIRE
