7 of 7
ISSUED: 03-26-10 SHEET #: 125-9106-6 12-11-14
© 2013, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
Mounting and Removing Flat Panel Screen
DETAIL 2
fi g 4.1
For preset tilt angles use Increlok
™ and for custom tilt
angle use ratchet handle.
INCRELOK
™
:
The screen can be locked into a
pre-set tilt position of -5
°
, 0
°
, 5
°
, 10
°
or 15
°
. Use
locator hole to fi nd tilt position hole and tilt screen to
align holes. Tighten IncreLok™ tilt locking screws on
both tilt brackets to lock tilt as shown in detail 2.
Ratchet Handle:
Loosen ratchet handle (refer to step
3 for tension adjustment of handle).
Push or pull from
top or bottom of screen to adjust tilt as shown in fi gure
4.1. The tilt can be adjusted to a maximum of 15°
forward or 5° backward.
Tension Adjustment of Ratchet Handle:
Adjust
tension in tilt brackets (
B & C
) by rotating ratchet
handle.
NOTE:
If obstruction prevents ratchet handle
from rotating, pull handle out while turning will allow
handle to reposition without tightening. Release and
turn handle to tighten or loosen.
Mounting Screen:
Ratchet handle
must
be in the
up or down position or interference will occur while
hooking tilt brackets to wall plate (
A
). Slowly hook tilt
brackets (
B & C
) onto wall plate (
A
) and swing screen
down as shown in fi g. 3.1. Tilt bracket hooks must
fully engage wall plate. Using phillips screw driver or
security allen wrench (
F
), turn safety/security screws
on tilt brackets (
B & C
) clockwise till screw tip securely
contacts wall plate as shown in cross section.
Screen Adjustment:
Screen can be adjusted
horizontally by loosening safety/security screws on
tilt brackets (
B & C
) three full turns. Adjust screen as
shown in fi gure 3.2. Tighten safety/security screws on
tilt brackets till screw tip securely contacts wall plate as
shown in cross section.
Removing Screen:
To remove screen from mount,
loosen safety screws, swing screen away from mount,
and lift screen off of mount.
3
Adjusting the Tilt Angle of the Flat Panel
Screen
4
• Always use an assistant or mechanical lifting equipment
to safely lift and position the fl at panel screen.
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount.
Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
• Be careful not to pinch fi ngers when pushing screen from
the bottom.
WARNING
fi g 3.2
IncreLok™
TILT
LOCKING
SCREW
SAFETY/
SECURITY
SCREW
CROSS SECTION
A
B
&
C
fi g 3.1
RATCHET
HANDLE
LOCATOR
HOLE
RATCHET
HANDLE
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.