V850ES/Jx3H – Plug it!
Note: Although the On-board debug interface is used, the MINICUBE2 C-Spy driver must be
selected instead of the standard driver TK-V850 used for other starter kits. If the debug
session via MINICUBE (QB-V850MINI) and the N-Wire connector shall be started, the
MINICUBE C-Spy driver must be selected.
Next the correct linker settings of the demo project will be checked. This can be done in the “Linker”
category as shown below. Select the “Config” tab and check that the linker command file “lnk70F3760.xcl” is
selected. This file is used by the linker and contains information on where to place the different sections of
code, data and constants that may be used within the demo project:
Figure 28: Embedded Workbench Linker Configuration
Now after everything has been setup correctly it’s time to compile and link the demonstration project. Close
the Options menu and select “Rebuild All” from the “Project” menu. If the project is compiled and linked
without errors or warnings it can now be downloaded to the
V850ES/Jx3-H - Plug it!
board and debugged.
To start the IAR C-SPY debugger select the option “Debug” from the “Project” menu or press the ( )
“Debugger” button.
User’s Manual U19647EE2V0UM00
37
