14 NEC PowerMate VT 300 Series Release Notes
Installing BootMagic in a System with Windows NT
BootMagic™ is a utility included in the PowerQuest PartitionMagic™ software.
See “Installing PartitionMagic” earlier in this document for general installation
information.
If you have a Windows NT operating system, use the information in the
following section to correctly configure BootMagic.
If you already installed BootMagic and the configuration resulted in an error
message, see “Correcting the BootMagic Configuration” later in this document.
Configuring BootMagic
If you have a system with the Windows NT operating system, use the following
procedure to correctly configure BootMagic.
1.
Follow the instructions in the PartitionMagic Userinfo folder to install
BootMagic. When the “BootMagic Configuration” box appears at the end of
the installation, continue to the next step.
2.
Configure BootMagic.
If you want to use BootMagic:
Click the
ENABLE BOOTMAGIC
button. The BootMagic menu appears
during the next bootup sequence and lets you select Windows NT as the
operating system.
If you do not want to use BootMagic:
Do not select the
ENABLE BOOTMAGIC
button. The BootMagic menu
does not appear at bootup.
3.
Select
SAVE/EXIT
in the BootMagic Configuration box to complete the
configuration process. Either choice, to enable BootMagic or to not enable
BootMagic, requires the SAVE/EXIT selection.
!
CAUTION
To correctly complete the BootMagic configuration, you must
select SAVE/EXIT from the BootMagic Configuration box,
even if you do not want to use BootMagic. Omitting this step
results in an error message.
