Configuring the System 3-55
!
MA: Master Select jumper
—
Enabled, pin 3 jumpered (factory default)
—
Disabled, pin 3 open
Zip Drive Jumpers
The three-position jumper block for the Zip drive is located on the rear of
the drive. This description applies when the rear of the drive is viewed
with the IDE connector to the left of the jumper block, and the power
connector to the right.
!
Drive 0 Select (Master Drive Select) - right two pin sets jumpered
!
Drive 1 Select (Slave Drive Select) - right-most pin set jumpered
!
Cable Sect Mode - all three pin sets jumpered
Tape Backup Unit Jumpers
!
Cable Select jumper - (1,2) Not used
!
Master device (5,6)
—
Enabled, DS jumpered
—
Disabled, DS open (factory default)
!
Slave device (3,4)
—
Disabled, open (factory default)
—
Enabled, jumpered