Configuring the System 3-49
Access the BIOS Setup utility and record your customized settings. See
“BIOS Setup Utility.”
Starting the system in Configure mode resets
BIOS settings to their factory defaults.
Before jumpering the system for Configure mode, write down any
customized BIOS settings. When the system is started in Normal mode,
press F2 to bring up the BIOS Setup utility. Recustomize your BIOS
settings.
1.
Power off and unplug the system and any external options. Remove
the system unit cover (see “System Unit Cover”).
The system power must be off before changing
a jumper setting.
2.
Locate the
J5G1
jumper block on the system board (see “System
Board Jumper Settings”).
3.
Move the jumper to pins 2 and 3. This jumper setting brings the
system up in Configure mode when it is rebooted.
4.
Replace the system unit cover (see “System Unit Cover”). Connect
system power cables and external options.
5.
Power on the system. The BIOS Setup utility launches immediately
after POST displaying the Maintenance menu.
6.
Select the Processor Speed field. Press
Enter
. A subwindow appears
displaying the supported processor speeds.
7.
Use the up or down arrow key to select the correct processor speed.
Press
Enter
.
8.
Select the Exit menu with the left or right arrow key. Press
Enter
to
exit saving changes. Press
Enter
again to confirm that you wish to
exit the BIOS Setup utility.
9.
Power off and unplug the system and any external options again.
Remove the system unit cover (see “System Unit Cover”).