![background image](http://html.mh-extra.com/html/nec/powermate-466m/powermate-466m_service-manual_248629093.webp)
3-36 Options
Finishing Minitower 5 1/4-Inch Device Installation
Replace the assemblies removed earlier and reconfigure the system as follows.
1.
Reinstall the 3 1/2-inch drive bracket by reversing the steps of the “3 1/2-inch
Drive Bracket Removal” procedure given earlier.
2.
Replace the top cover and run Setup to reconfigure the computer for the hard
disk drive (see Section 2, Setup and Operation). If a fault occurs at power-on,
verify that the reassembly was performed correctly.
3.
Reconfigure the computer for the hard disk drive by selecting hard disk drive “In-
stalled” in Setup. Setup will automatically detect the hard disk type. When in-
stalling a hard disk drive that cannot be detected, use the “Define Hard Disk
Type” to determine the hard disk drive type.
Hard Disk Drive Troubleshooting
One beep indicates that the computer has completed its power-on self-test. If intermittent
beeping occurs, turn off the computer and try again. If the beeping persists, see Section 4
“Maintenance and Troubleshooting.”
Summary of Contents for PowerMate 466M
Page 10: ...Contents xiii ...
Page 176: ...Connector Pin Assignments A 15 ...