6-20 Minitower Repair
Battery Removal
Remove the battery per Figure Section 6-19 and the following steps.
1.
Remove the top cover and as previously described.
2.
Remove the two 3 1/2-inch diskette drive bracket screws from the front of the
system unit (see Figure Section 6-15).
3.
Slide the 3 1/2-inch diskette drive with bracket out of the system unit. (The
bracket works like a drawer and will stop when fully out.)
4.
Lift the battery spring clip securing the battery in the battery socket on the system
board.
CAUTION:
When replacing the battery be sure
to insert the battery so that the positive side is
facing up.
Figure Section 6-19 Battery Replacement
5.
After installing a new battery, the time, date, etc. may need to be reset. Run the
Setup utility that came with the system (see Section 2).
Clip
Battery
Summary of Contents for PowerMate 466M
Page 10: ...Contents xiii ...
Page 176: ...Connector Pin Assignments A 15 ...