NEC NF2900-SR40E, User Manual

Page: 63 / 168

46
(1) Power check
Make sure that the power switch of the disk enclosure to be added is set to OFF and the plugs of the
power cords are removed from the AC outlet.
The power to the disk array and host system may be set to ON; however, it is recommended to do this
procedure with the power switches set to OFF.
(2) Connection of a FC disk enclosure (NF2500-SE42E)
Push the connector of the FC cable (HSSDC-HSSDC) provided with the FC disk enclosure, or the
optional DE (HSSDC) cable (NF9120-SJ34E) into the FC connector (DP1/2/3) of the FC disk
enclosure of the Controller 0 (CONT0) installed in the disk array unit until a click is heard.
The cable has the same connectors at both ends. Either connector may be connected to the controller.
Push the connector at the other end of the cable into the FC-IN connector on Adapter 0 (ADP0) of the
FC disk enclosure until a click is heard.
Similarly, connect the FC connector (DP1/2/3) for the FC disk enclosure of the other Controller 1
(CONT1) installed in the disk array unit to the FC-IN connector on Adapter 1 (ADP1) of the FC disk
enclosure.
NOTES: Extension of the disk port is required for the connections with DP 2/3 by extension of
the option.
Connection of a SATA disk enclosure (NF2500-SE82E)
Push the connector of the FC cable (HSSDC-HSSDC) provided with the FC disk enclosure, or the
optional DE (HSSDC) cable (NF9120-SJ34E) into the SATA connector (DP1/2/3) for the SATA disk
enclosure of the Controller 0 (CONT0) installed in the disk array unit until a click is heard.
The cable has the same connectors at both ends. Either connector may be connected to the controller.
Push the connector at the other end of the cable into the FC-IN connector on Adapter 0 (ADP0) of the
SATA disk enclosure until a click is heard.
Similarly, connect the SATA connector (DP1/2/3) for the SATA disk enclosure of the other Controller
1 (CONT1) installed in the disk array unit to the FC-IN connector on Adapter 1 (ADP1) of the SATA
disk enclosure.
NOTES: Extension of the disk port is required for the connection with DP 2/3 by extension of
the option.
For more information regarding the cable connection and setting of the ENC ID switch, please refer
Section 5.2 (4)
“Setting of switches”.