82
Projector Adjustment and Connecting
3-3. Turning your Projector On
NOTE
• Do not use the projector with the lens cap left attached, and do not attach the lens cap while the projector is
operating. The lens cap may become hot, causing them to deform or melt.
• In the following instances, the power to your projector cannot be turned on even if you press the POWER
button.
- When the inside temperature is abnormally high. The protective function prevents power from turning on.
Wait some time (until the projector inside cools down) and then turn on the power.
- When the SYSTEM status indicator is blinking without the light source lighting up after power-on. Your
projector may be in trouble. Check the error display on the LCD screen and contact your dealer/distributor
for instructions.
Preparation:
• Connect the power cable to the projector (See Projector User’s Manual).
• Connecting the Power Cable to the Chiller Unit (See page 64)
• Connecting the Hoses to the Chiller Unit (See page 71)
• Connecting the Control Cable (See page 73)
• Pouring the Coolant (See page 74)
• Supply AC power to the projector.
1
Remove the lens cap.
2
Turn ON the emergency stop switch (AC power switch) of chiller unit.
3
Insert the administrator key vertically and turn it to the horizontal direction. The administrator
key can no longer be removed. The projector will not function unless the administrator key is
inserted.
4
Turn on the main power switch on the side of the projector.
A buzzer will ring on the projector. The POWER button indicator will blink green and the SYSTEM status indicator will
light orange (standby state). KEY LOCK becomes automatically on if no control panel operation takes place in the
standby state for 30 seconds by default. Buttons on the control panel do not function while KEY LOCK is on.
5
If KEY LOCK is on, press the KEY LOCK button for one second or longer.
KEY LOCK becomes off. The KEY LOCK button indicator turns off and buttons on the control panel become
operable.
6
Press the POWER button on the control panel of your projector three seconds or longer.
7
Press the LIGHT ON/OFF button on the control panel for three seconds or longer.
The light source is turned on and the screen glows light about 15 seconds later.
The douser is closed until the screen glows light (the DOUSER button indicator lights green). When the douser is
open, the DOUSER button indicator turns off.
3-4. Setting the Date and Time in the Projector
The internal clock in the projector operates on coordinated universal time (UTC). You can set the internal projector time to the
time in your region by setting the time difference between the standard time in your region and UTC.
If you are using DCC, you can easily set the date and time in the projector by reading the date and time settings of the computer
where DCC is installed. Refer to “Digital Cinema Communicator for S2 Installation Manual” for details.
