102
LCD Menu
Fan Speed Mode
It adjusts the rotation speed of the internal cooling fan.
←
Displays the currently selected item with asterisk (*).
←
Displays the setting.
Auto
The fan rotates at the optimal speed according to the temperature sensor inside the projector.
High Speed
The fan always rotates at high speed.
High Altitude
Select when using the projector in locations with low air pressure, such as at high elevations of
altitude approximately 5500 feet (1600 m) or higher. The fan always rotates at high speed.
NOTE
• It is recommended that you select “High Speed” if you use the projector non-stop for consecutive days.
• Set “Fan Speed Mode” to “High Altitude” when using the projector at altitudes approximately 5500 feet/1600
meters or higher.
• Using the projector at altitudes approximately 5500 feet/1600 meters or higher without setting to “High Altitude”
can cause the projector to overheat and the protector could shut down. If this happens, wait a couple minutes
and turn on the projector.
• Using the projector at altitudes approximately 5500 feet/1600 meters or higher can shorten the life of internal
parts.
Service Adj.
This is used during shadow adjustment and lens mount adjustment (focus balance adjustment). This menu item can only be
used while in standby. If you press the <ENTER> button and then select “Yes” and press the <ENTER> button on the confirma-
tion screen that is displayed, the projector starts automatically and a yellow colored light ring is projected. You can adjust the
output level of the light source (Light Setup) even while using Service Adjustment.
←
Press the ENTER button to display the confirmation screen.
LD Calibrate
Calibrates the light source unit when it is replaced with a new one. This menu item is available only when the power to the
projector is turned on.
←
Press the ENTER button to display the confirmation screen.
Sensor Calib.
Calibrate the sensors upon installation. Consult the dealer/distributor for how to use the unit.
