NEC N8406-023, Command Reference Manual

Page: 26 / 156

N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (ISCLI) 26
The following table describes the user status information.
Table 16 User status Information
Field Usage
user
Displays the status of the
user
access level.
oper
Displays the status of the
oper
(operator) access level.
admin
Displays the status of the
admin
(administrator) access level.
Current User ID Table
Displays the status of configured user IDs.
Layer 2 information
The following table describes the Layer 2 Information commands. The following sections provide more detailed
information and commands.
Table 17 Layer 2 information commands
Command Usage
show mac-address-table
Displays Forwarding Database Information.
Command mode : All
show lacp information
Displays a summary of LACP information.
Command mode : All
show qos transmit-queue information
Displays 802.1p Information.
Command mode : All
show dot1x information
Displays 802.1x Information.
Command mode : All
show spanning-tree stp < 1-128 >
information
I n addition to seeing if STP is enabled or disabled, you can
view the following STP bridge information:
Priority
Hello interval
Maximum age value
Forwarding delay
Aging time
You can also refer to the following port-specific STP
information:
Port number and priority
Cost
State
Command mode : All
show spanning-tree mstp cist
information
Displays Common internal Spanning Tree (CIST) bridge
information, including the following:
Priority
Hello interval
Maximum age value
Forwarding delay
You can also view port-specific CIST information, including
the following:
Port number and priority
Cost
State
Command mode : All
show portchannel information
When trunk groups are configured, you can view the state
of each port in the various trunk groups.
Command mode : All
show vlan information
Displays VLAN configuration information, including:
VLAN Number
VLAN Name
Status
Port membership of the VLAN
Command mode : All
show layer2 information
Dumps all switch information available from Layer 2
memory (10K or more, depending on your configuration).
If you want to capture dump data to a file, set your
communication software on your workstation to capture
session data prior to issuing the dump commands.
Command mode : All