1. Installing Internal Optional Devices
Express5800/R120d-2M User’s Guide
93
Chapter 2 Preparations
1.17.5
Installing RAID Controller
This section describes how to install an optional RAID Controller to the slot dedicated to RAID Controller.
(1) When using the optional RAID controller (N8103-149/150/151/160)
For details, refer to the manual that comes with optional RAID Controller (N8103-149/150/151/160).
Important
•
You must avoid static electricity to work with the procedure below. For
details, refer to
Chapter 2 (1.2 Anti-static Measures)
.
•
Do not change the mode to hibernate during building a RAID System.
Note
•
When installing an optional RAID Controller, start the BIOS Setup utility, select
PCI Configuration
from the
Advanced
menu, and then make sure that the
parameter of
PCI Slot
xx
ROM
(
xx
is PCI slot number) is set to
Enabled
.
•
When connecting a RAID Controller, set the boot priority to 8th or higher in the
Boot menu of the BIOS Setup utility. If the setting is 9th or lower, the
configuration menu for RAID Controllers cannot be launched.
Take the following procedure to install RAID Controller (N8103-149/150/151/160).
1. Refer to step 1 to 6 in
Chapter 2 (1.3 Overview of Installation and Removal)
for preparations.
2. Remove the four screws and
remove PCI riser card.
3. Remove the two screws from
RAID Controller, and remove PCI
bracket.
4. Remove the two screws from
server chassis, and remove RAID
Controller bracket.
5. Attach the RAID Controller bracket
to RAID Controller with two screws
you have removed in Step 4.
Ports 4-7
Ports 0-3
