1. Turning on the Server
Express5800/R120d-2M User’s Guide
125
Chapter 3 Setup
1.1
POST
POST (Power-On Self-Test) is a self-diagnostic program stored in the server as standard. POST
automatically runs immediately after the server is turned on and checks the motherboard, memory, and
processor (CPU). POST also displays the start-up messages of different utilities during the operation.
Usually, you do not need to check the contents of POST.
However, check messages displayed at POST
in the following cases.
•
When introducing a server
•
If you suspect a failure
•
When you hear beep many times during the time between Power ON and OS startup
•
When any error message is displayed
1.1.1
POST sequence
Explains how POST runs in order.
1. When the server is turned on, POST runs.
As factory settings, the logo appears on the screen during POST.
Note
Keyboard becomes operable after the logo appears.
2. If
Enabled
is specified for
Password On Boot
in
Security
menu of SETUP, you will be prompted
to enter password after the logo is displayed. If you enter the incorrect password three times
consecutively, POST aborts. (You can no longer proceed.) In this case, power off the server, and
power it on.
Important Do not set a password before OS is installed.
3. If <Esc> key is pressed, the logo disappears and the details of POST are displayed.
Tips
If
Quiet Boot
is
Disabled
from
Boot
menu in BIOS settings, the logo is not
displayed without requiring <ESC> key to be pressed.
4. POST displays several types of message. These messages let you know that the installed CPU or
connected keyboard and mouse are detected.
5. After a while, the following message is displayed on the screen.
Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
By pressing the designated function key following messages, you can call the functions below
upon completion of POST.
<F2> key: Run BIOS Setup Utility (SETUP). For information on the SETUP, refer to
Chapter 2 (1.
System BIOS)
in "
Maintenance Guide
"
.
