58
10-2. Setting MMS Link Mode Using the PC Control Software
This section describes information on how to make the settings required for interface with the MMS 1000
(MMS Link Mode) using the MMS Control command included in the Advanced menu of the PC Control
Software. (Up to two units of MMS 1000 can be connected to Model iS8-2K --in single connection--, and one
unit of MMS 1000 to Model iS10.)
1. Enter the IP address or host name of the MMS
1000 to be controlled from your projector (Port
7142 is fixed). Click the Use checkbox and then
click the Apply button.
When link is established between your projector and the MMS
1000, the following status message appears on the LC display
of the projector. (The LC display message is updated every 3
minutes or at each key operation.)
On standby
At power on (MMS-1 Link Mode)
Notes:
• If you change an MMS 1000 slot (change of board) after cataloging it as a title on your projector, you will not be able to select
that title (the title characters should have turned gray). Recatalog so that you can restore and select it.
• MMS link may sometimes be cancelled if you operate the MMS
1000 while your projector is accessing it (e.g., change of input
source). In such a case, you must make MMS control settings
anew on your projector. (Characters of the corresponding set-
tings should have turned blue.)
• Projector reaction will slow down if you disconnect the LAN cable between your projector and the MMS 1000 when MMS
control is enabled on the projector. Projected images are not affected though.
