NEC iS15-2K, User Manual

Page: 70 / 90

page 5.4
5. Maintenance
iS15-2K
Cinema Projector: User Manual
Changing the lamp
The lamp should be changed, by certified service personnel, after 750 hours of use,
as indicated on the lamp-hours meter. The meter is located on the front of the lamp
module, and is accesible inside the lamp compartment door.
Lamp-hours meter
Notes
The lamp should be changed
ONLY by certified service
personnel.
Always allow the lamp to cool
for 5 minutes before
removing the lamp module.
Do NOT open the lamp
compartment door whilst a
film is being shown - safety
interlocks on the door will
shut down the projector
without warning.
Do not use the lamp for more
than 750 hours, as this may
cause serious lamp failure,
damage the lamp module and
cause extra cost on
replacement.
Warranted lamp life is
determined by the reading on
the Lamp-hours meter on the
face of the Lamp module,
shown here - NOT the reading
available via the Information
menus.
There are no user-serviceable
parts inside the lamp module.
The whole module should be
replaced and returned to your
provider for re-furbishment.
Xenon lamps produce high
intensity light. Do not look
directly at the light coming
from the lamp housing or the
lens.
LCD meter
display button
The Lamp-hours meter has two modes of operation:
• When the projector is running, the LCD will show lamp run hours.
• When the projector is in Standby mode, the LCD will be blank. To display lamp
run hours press the button and hold for 5 seconds.