page 5.2
5. Maintenance
iS15-2K
Cinema Projector: User Manual
Changing the air filter material
To change the filter:
Switch the projector into
Standby mode
, by pressing the
POWER
button on the
control panel or the
POWER OFF
button on the remote control for two seconds.
•
The
ON/STANDBY
indicator on the control panel will change to orange, and
flash on and off.
The display will show the Cooldown timer, which will count down from
300 seconds to zero. At the end of the cooling period, the projector will go into
Standby mode
.
•
Push the main power switch downwards to switch off the power.
•
Pull the filter out from under the front of the projector, under the lens, by pulling
on the strap.
•
Inspect the foam sealing strips at the ends and sides of the filter. If they are
damaged, then the whole filter should be replaced.
•
Dismantle the filter:
- Remove the two screws securing the strap-end of the frame.
- HInge up the top of the frame and unhook from the bottom end.
- Remove the filter material.
Notes
The projector must be
switched OFF before
removing the air filter,
otherwise dust could be
sucked into the projector by
the ventilation fan.
The filter material should be
changed regularly:
•
In a clean environment such as
a projection room, change after
750 hours, at the same time as
the lamp is changed.
•
In a dusty or smoky
environment such as a theatre
or public area, more frequent
changes may be necessary.
Summary of Contents for iS15-2K
