CHAPTER 3 INSTALLATION
User’s Manual U16115EJ2V0UM
27
<2> Prepare the IE-789306-NS-EM1.
<3> Remove the crystal oscillator that is mounted in the IE-789306-NS-EM1’s X1 socket.
<4> Connect the parts board (from <1> above) to the X1 socket from which the crystal oscillator was
removed. Check the pin 1 mark to make sure the board is mounted in the correct direction.
<5> Make sure that the parts board is wired as shown in Figure 3-9 above.
<6> Install the IE-789306-NS-EM1 in the IE-78K0S-NS or IE-78K0S-NS-A.
The above steps configure the following circuit and enable supply of the clock from the mounted resonator
to the emulation device.
(b) When using a crystal oscillator
•
Items to be prepared
•
Crystal oscillator (see pinouts shown in Figure 3-10)
Figure 3-10. Crystal Oscillator (Main System Clock)
<Steps>
<1> Prepare the IE-789306-NS-EM1.
<2> Remove the crystal oscillator that is mounted in the IE-789306-NS-EM1’s X1 socket.
<3> Connect a crystal oscillator to the X1 socket from which the crystal oscillator was removed (in <2>
above). Insert the pins of the crystal oscillator into the socket aligning the pins as shown in the figure
below.
V
CC
CLOCK OUT
GND
NC
