i-Series Gateway
Page 12
G-6000G-SKE, Rev AA
$V\QFKURQRXV6HULDO593B'LUHFW
Introduction
This section of the guide provides the necessary information to configure the
i-Series Gateway for connection to an asynchronous-serial device. The units are
programmed at the factory with “default” settings providing basic parameters to
accommodate many network environments.
Figure 5. Async Connections
Prerequisites for Configuration
The i-Series Gateway (at the corporate site) and the i-Series 6000
TM
Extender (at the branch office)
must be installed properly and the network link between both devices must be operational.
The network administrator must assign an IP address for both units in order to configure and test them
over a LAN or WAN.
Basic Configuration
Table 6. Configuration Steps
You must … to…
Default settings
Refer to System
Administrator’s
Guide
Enable the WAN port.
Enable WAN functions
WAN 1
Chapter 4, Enabling
WAN Port, page 73.
Set the mode (interface
type) of the WAN port.
Match the interface type
of the network device.
V.35 Chapter
4,
Setting the
Mode, page 80.
Set the Async parameters
for the selected WAN port.
Match the settings for the
device being used.
- Chapter
4,
Setting
ASYNC Parameters,
page 76.
Set the Jitter Delay and
Compression settings.
Match the settings for the
device being used.
- Chapter
4,
Setting Jitter
and Compression, page
79.
Punch Block
ISD N
PBX
C orporate Facility
Punch Block
i-Series G atew ay
i-Series 6000
Extender
ISD N TA
ISD N TA
