i-Series Gateway
Page 10
G-6000G-SKE, Rev AA
Installation Environments
Introduction
Which type
of Network
Device do
you have?
This section of the guide provides the necessary information to configure the i-Series
Gateway using the MI. The units are programmed at the factory with “default” settings
providing basic parameters to accommodate most network environments.
Before beginning the configuration process, it is necessary to identify the type of
network device connected to the i-Series Gateway. Once you know the connection type,
use Table 4, below, to find the appropriate configuration checklist.
Table 4. Network devices
To configure the
i-Series
Gateway with …..
See page…..
A Synchronous-Serial device – V.35,
RS-232, RS-530 via WAN Port
(RVP_Direct)
11
An Asynchronous -serial device via WAN
Port(s) 1 or 2
(RVP_Direct) using RS-232 Protocol.
12
An IP* device – via Ethernet port
(RVP_IP)
* IP-based products from NEC America,
Inc. utilize Voice over IP (VoIP) technology
to deliver remote voice solutions. The voice
quality of these solutions is dependent on
variables such as available bandwidth,
network latency and Quality of Service (QoS)
initiatives, all of which are controlled by the
network and Internet Service Providers.
Because these variables are not in NEC
America, Inc. control, it cannot guarantee
the performance of the user’s IP-based
remote voice solution.
13
