English
- 4
Recommended Use & Maintenance
About the LED lamps
The surface of the pixel card is vulnerable to shocks, so do not press or hit the surface.
LED lamps are sensitive to static electricity and surge voltage, which may damage their components
and decrease their reliability.
Take measures against static electricity during the installation. Do not touch the LED display areas.
When you install the product or when you use it for the first time after leaving it unused for a long
time, follow the instructions below.
The LED lamps may absorb and hold moisture during the LED module installation or if not used for
a long time. Therefore, in such cases, the brightness must be increased gradually during a break-
in period before setting the normal brightness.
If the LED lamps are lit with 100% brightness while moisture is retained, the temperature will
rise very quickly and the water inside the lamps will evaporate and expand. This will cause the
encapsulating resin to expand, which may lead to separation of the boundary surface inside the
LED lamps. This separation can cause the LED lamps not to light up properly.
Lamp break-in
Configure the brightness settings as shown below with a video displayed on the LED
module.
After a break-in period of approximately 3 hours, the LED module can be used under
normal conditions.
Time since start-up: 0
(just after start-up)
1 hour
2 hours
3 hours
Full white
Normal operation
70%
50%
80%
60%
40%
Brightness
value 20%
Normal operation
Video content
About the Pixel card
The surface of the pixel card is easily scratched, so handle it with care so as not to push or rub it with
a hard object. Be careful not to stain the surface of the pixel card with your fingers. If the surface of
the pixel card becomes dirty, wipe it gently with a dry cloth. Also, use a clean cloth and avoid using the
same cloth repeatedly.
