1. Installing Internal Optional Devices
Express5800/T110i-S User’s Guide
72
Chapter 2 Preparations
Installation
1.12.1
Install a backup device by using the following procedure.
1.
See
Chapter 2 (1.2 Overview of Installation and Removal)
for preparations.
2.
To remove the side cover and the front bezel, see
Chapter 2 (1.3 Removing the Side Cover
and
.
3.
Remove the blank cover. Push the tab on the tray
and pull out the device tray from the 3.5-inch
expansion bay.
4.
Mount the backup device on the device tray. Secure
the backup device on the left and right sides by
using the two screws that come with the server.
Important Use two screws supplied with this server to attach the backup device to the
tray.
5.
Insert the backup device into chassis.
Do not push the backup device in completely as the
cable has to be connected to the device.
6.
Connect the interface cable and power cable to the installed backup device.
For more information, see
Chapter 2
.
7.
Push the device all the way until it locks with a clicking sound.
Tips
Arrange the unused power supply cable at the rear of the backup device so that
this cable comes between the HDD cage and optical disk drive. Be careful not to
apply a force to the I/F cable connector when pushing in the backup device.
8.
Assemble the server.
9.
Install device drivers for installed backup device as needed.
For more information, refer to the manual provided with the backup device.
Removal
1.12.2
You can remove the backup device by reversing the installation procedure.
1
2
