57
6. Appendix
6-5. Specifications
Model No.
Projection method
Panel resolution
Lamp type
Screen sizes
Contrast ratio
Lens adjustment function
Signal input ports (Note 2)
External Control
Power supply
Power consumption
Cooling method
Noise level
Installation
Net weight
Dimensions
Environment
Regulations
NC2000C
3 chip DLP Cinema
®
method (0.98-inch DC2K chip)
2048 x 1080
4.0 kW xenon lamp (Note 1)
5 m to 20 m (Width) (Depends on setup conditions)
2200:1 or above
Motorized lens shift (vertical/horizontal), motorized zoom, motorized focus, douser
Signal input board (NC-80LB01) mounted as standard
Slot B
SDI (4) BNC (SMPTE 292M, 372M)
RGB DIGITAL (2) DVI-D 24pin (TMDS specification)
Slot A
When shipped from factory: Empty (for mounting optional components)
RS-232C D-sub 9 pin x 1
GPIO port D-sub 37 pin x 1
Remote control input port stereo mini jack x 1
3D CTL D-sub 15 pin x 1
USB Type A x 1
Interlock port x 1
Ethernet port G-bit RJ-45 x 1
Anamorphic Lens Turret control port x 1
For C1 connection (Note 3)
Single phase AC 200V-240V 50/60Hz 30A (projector power
lamp power supply)
For C2 connection (Note 3)
Single phase AC 100V-240V 50/60Hz 5–2.5A (projector power
supply)
Single phase AC 200V-240V 50/60Hz 27A (lamp power supply)
5500W
Cooling fluid system, Cooling air system (includes dust filter)
Less than 62 dB
Orientation:Desktop/front, Desktop/rear
99 kg (Excluding lens)
700 mm (W) x 990 mm (D) x 503 mm (H) (Does not include protruding portions Includes foot)
Operating temperature: 10 to 35˚C
Operating humidity: 10 to 85% (non-condensing)
Storage temperature: -10 to 50˚C
Storage humidity: 10 to 85%
<Safety>
<EMC>
USA
UL60950-1
FCC Class A
Canada
CSA60950-1
ICES-003 Class A
Europe
EN60950-1
EN55022 Class A
EN55024
Oceania
IEC60950-1
AS/NZS CISPR.22 Class A
Japan
J60950
VCCI Class A
Asia
IEC60950-1
CISPR. 22
(Note 1)Using any lamp other than NEC’s optional lamps will result in lower brightness compared to NEC optional lamps. If
brightness is important to you, it is recommended that you use NEC’s optional lamps.
NEC will post information on its homepage regarding installable lamps, other than NEC’s optional lamps. Note that
NEC does not guarantee performance and reliability when lamps other than NEC’s optional lamps are installed.
(Note 2)In addition to the input ports described above that are mounted when the device is shipped, Image Media Block and
Multi Media Switcher are available as separate optional products. A wider variety of input interfaces can be supported
by mounting these in slot A.
(Note 3)C1 connection is the case when the AC power to the projector power supply and the lamp power supply is provided by
a single cable.
C2 connection is the case when the AC power to the projector power supply and the lamp power supply is provided by
separate cables.
* Note that these specifications and design can change without prior notice.