3-24 Option Installation
NOTE:
If you removed the side cover on your
minitower or the accessible device cage on your
desktop, replace it. Secure the device cage with
the screw.
11.
If you installed a hard drive in the 5 1/4-inch slot, replace the plastic panel.
12.
Replace the front panel.
13.
Replace the access cover.
Accessing the CD-ROM Reader
If you need to access the CD-ROM reader, you need to remove the side cover on the
minitower or the accessible device cage on the desktop.
For the minitower, pull out the side panel securing tabs and slide the panel towards the rear
of the system. If it is tight, insert a screwdriver into the slots between the cover and the
front panel and carefully pry it loose.
For the desktop, use the following procedure to remove the accessible device cage.
1.
Locate the screw on the front of the system between the 3.5-inch blank panel and
diskette drive. Remove the screw.
2.
Slide the cage towards the front of the system and lift it out of the unit.
Replacing the Front Panel
To replace the front panel, follow this procedure.
1.
Align the front panel’s six tabs with their corresponding slots on the system (three
of the tabs have holes, the others have prongs).
2.
Press the front panel squarely into position until the tabs lock the panel in place.
3.
Replace the access cover.
4.
After securing your system, reboot it and run the Setup program to set the new
configuration.
Summary of Contents for Direction T-Series
Page 8: ...Contents ix...
