Neatech PROFESSIONAL REHAB Series, Service Manual

Page: 42 / 220

www.neatech.it
30/203
3.3 Speed limitations
Programming must be conducted only by qualified personnel with in-
depth knowledge of the wheelchair and power module system.
Any change to this part of the software may result in a hazardous situation
for the user.
The maximum speed of the wheelchair is automatically limited according to the position of the
seating system. There are four different bands. To set the speed reduction in each band set the
specific values in the rows shown in figure. In order to find this section, open the programmer
software and go into the section INHIBITS>DRIVE INHIBITS. For more information see section
2.1.2 .
Figure 28
The wheelchair is considered in BAND 1 when one of following conditions occurs: the height of
seat is higher than the value set in Parameter 1 - Axis 12; the angle of the seat is greater than
the value set in Parameter 3 - Axis 12; the seat is forward tilted with an angle of more than 10°
(Seat angle<-10). The wheelchair is considered in BAND 2 when one of following conditions
occurs: the height of the seat is more than the value set in Parameter 2 - Axis 12; the seat is
forward tilted of more than 20° (Seat angle<-20). The wheelchair is in BAND 3 when there is the
possibility for legrest to crash into the floor.
As default the speed is limited at 0%. Please don't
change this value.
Modify only parameters in:
SPEED LIMIT IN BAND 0
SPEED LIMIT IN BAND 1
SPEED LIMIT IN BAND 2
Do not modify any other parameter in this section.
AXIS 12 PARAMETERS .