NDUSTRIA™ Infrared Electric Manual
6
3.2.3 Adusting Directional Positioning
1. Power to heater from main supply must be OFF to
adjust the position. (Turn off circuit breaker.)
2. Allow heater to cool before re-positioning the angle.
3. Loosen fi xing bolts on the brackets at the rear of the
heater; re-position heater as desired, then re-tighten
the fi xing bolts.
CAUTION: DO NOT position or mount heater other
than angle specifi ed in Figure 1 and Table 1.
3.3 Operation of Models NEL-15(B/G) and NEL-
15(B/G)-RM
1. Turn heater on. Heater has red ON/OFF switch
(Models NEL-15(B/G)) or I/O/II switch (Models NEL-
15(B/G)-RM) located on end of heater.
2. Observe operation for 10 to 15 minutes to be sure
heater is working properly.
If there is an operation problem, immediately turn
OFF heater or push switch to O position to turn off
heater and disconnect power.
3. Turn heater OFF when not in use by pushing switch
to O position.
• It is recommended to wall mount heaters. However,
ceiling mounting is acceptable provided the folowing
conditions are met: DO NOT position or mount heater
other than angle specifi ed in Figure 1 and Table 1 and
18” (0.45m) from combustible ceiling.
WARNING
Burn Hazard
Keep all persons, especially children, away
from heater.
Do not touch any part of the heater.
Heater is very hot.
Failure to follow these instructions can result
in death, injury or property damage.
WARNING
Fire Hazard
Turn off heater when not in use.
Failure to follow these instructions can result
in death, injury or property damage.
DANGER
Electrical Shock Hazard
Disconnect electrical supplies before
performing service or maintenance.
Installation must be done by a certified
electrician and must adhere to local, state
and national electrical codes.
Control must be properly grounded to an
electrical source.
Failure to follow these instructions can
result in death, electrical shock or property
damage.