NCR RealPOS 70XRT, User Manual

Page: 156 / 183

14-4 Chapter 14: BIOS Updating Procedures
5. Make a menu selection and follow the screen prompts (Option 1 is
recommended).
1 Update SPI and BIOS – No prompt for Serial/Model/Class unless invalid
2 Update BIOS only – No prompt for Serial/Model/Class unless invalid
***** Forced Update of Serial/Model/Class Information *****
3 Update DMI only – Serial/Model/Class update ONLY (no BIOS or SPI Update)
4 Update of SPI and BIOS – Always prompts for Serial/Model/Class
5 Update of BIOS only – Always prompts for Serial/Model/Class
***** For Service Personnel Only *****
6 Update of SPI and BIOS – Reset to Default Serial/Model/Class information
Option 1 – Update SPI and BIOS – No prompt for Serial/Model/Class unless invalid
1. Highlight Option 1 and press
[ENTER]
. (Executes automatically in 10 seconds
unless the up/down arrow is pressed.)
2. The Flash Program updates the SPI/BIOS, automatically powers down for about
20 seconds, and then reboots the terminal.
3. After a few seconds the terminal reboots again.
4. As the terminal reboots select the boot media again [F8] (if necessary) to have the
terminal boot from the SPI/BIOS media.
5. Let the terminal boot from Option #1 (default).
6. The Manageability Engine (ME) is programmed and a message is displayed
indicating power must be removed before continuing. Press [3] to perform a 20
second AC power removal (automatically executes in 2 minutes if no keys are
pressed).
7. Remove the SPI/BIOS Update media before the system boots.
8. System is ready for operation.