NCR 7454, User Manual, Page: 187 / 244

Chapter 5: BIOS Updating Procedures 5-3
6. Press
F2
at the screen prompt to enter the Setup Utility.
7. In the
Advanced
menu, select
I/O Device Configuration
.
8. Verify that the
LPT 1 Mode
is set to
ECP
.
9. Go back to the
Advanced
menu, select
Multiple ROM Menu
.
10. Set the
Parallel CD-ROM Boot
to
Enabled
.
11. Exit Setup and Save Changes.
As the terminal reboots, you should see a message during boot
indicating that the CD-ROM has been recognized:
Micro Solutions BACKPACK CD-ROM v0.3
. . .
Booting from BACKPACK CD
Starting MS-DOS
12. Follow the screen prompts on the client to update the BIOS. You
can select two methods to run the update program.
•
Automatic BIOS Update – update process runs unattended
Note:
You see a prompt for terminal model and serial number
information. If the program detects invalid information in the
current BIOS, or if you are replacing the Processor Board, there
is not model/serial number information in the BIOS.
Important: Model/Serial Number is mandatory for FitClient
operation.
•
Interactive BIOS Update – permits you to input/replace the
model/serial number information that is stored in the BIOS.
Note:
Model/Serial number data that is currently stored in the
BIOS is displayed during power up.
13. When you get the green window, this indicates a successful update.
14. Remove the CD and then press any key to reboot.
13. When the system reboots, press
F2
at the screen prompt to enter
Setup.
14. In the
Exit
menu, select
Load Setup Defaults
.
15. Exit Setup and Save Changes.