NCR 7454, User Manual, Page: 125 / 244

Chapter 3: Setup 3-33
Legacy Diskette
The terminal does not have a flex disk drive. Therefore this option is
unused, even though Setup defaults to
1.44 MB, 3 ½" .
Primary Master
After installing a new hard drive, the system should automatically
detect the drive. If this is not done automatically and you need to
configure the IDE Adapter, perform the following steps:
1.
Move the cursor to the Primary Master option, press Enter and the
following sub-menu appears.
Primary Master [2163MB] Item Specific Help
Type: [Auto]
Cylinders: [ 4200]
Heads: [ 16]
Sectors: [63]
Maximum Capacity: 2168MB
Multi-Sector Transfers: [16 Sectors]
LBA Mode Control:
[Enabled]
32 Bit I/O: [Disabled]
Transfer Mode: [FPIO 4/DMA 2]
Ultra DMA Mode: [Mode 2]
2. Use the F5 and F6 keys to select the Type of hard disk. If Auto is
selected, the fields are automatically filled, based upon the installed
drive.
3. Press Esc to return to the Main Menu .
4. Move the cursor to the Exit menu, select Exit Saving Changes or Save
Changes , and press Enter.
Main
Exit Submenu
PhoenixBIOS Setup Utility