NCR 6932, User Manual, Page: 61 / 108

Configuration 3-49
Factory Default Setting
There are two ways to reset the keyboard to Factory Defaults state:
• Software control through utility application
• Hardware keyboard operation
Software Control through Utility Application
To reset the keyboard to its factory default state using software control, refer to the
section for the configuration utility application that you are using:
• NCR Matrix Maker
• NCR 5932-66xx Windows Configuration Utility
Hardware Keyboard Operation
To reset the keyboard to its factory default state using hardware keyboard operation,
perform the following steps:
1. Set Key Lock to the " L " position.
2. Press Ctrl+Alt keys.
3. While holding down the Ctrl and Alt keys, set the Key Lock to the " Ex " position.
(Flash memory will be erased at this time.)
4. Release all pressed keys and unplug the keyboard cable from the host terminal.
5. After a few seconds, plug the keyboard cable to the host terminal.
(Flash memory will be initialized to the factory defaults state at this time.)