53
NH 2001M
NBase Communications
Spanning Tree Commands
Spanning Tree automatically configures a loop-free topology in a bridged
environment. Type
<sp-tree>
to view all the related commands. The
Spanning Tree agent is implemented in conformance to the IEEE 802.1d stan-
dard. Listed below are the configuration commands pertinent to the operation
of the Spanning Tree algorithm.
get-stp
Retrieve the current state of Spanning Tree. Options are enable or disable.
set-stp
This command enables or disables the Spanning Tree protocol. Spanning Tree
is enabled by default, in accordance with 802.1d. Enabling or disabling
Spanning Tree will not take effect until the SNMP agent is reset, via warm-
reset, cold-reset or a power cycle.
Usage:
set-stp {enable|disable}
get-st-bcfg
This command retrieves the Spanning Tree bridge parameters. If Spanning
Tree is disabled, no parameters will be retrieved.
get-st-pcfg
This command retrieves the Spanning Tree port parameter table. If Spanning
Tree is disabled, no parameters will be retrieved.
get-st-syscfg
This command retrieves the Spanning Tree state of all the ports.
AI2001SB.QXD 4/5/98 11:27 AM Page 53
