(11) Nozzle Position Control
Notices before adjusting nozzle
- Make sure that temperature is low.
- Make sure that power and air are off.
- After manually adjusting nozzle, do the
precise adjustment with power and air on.
Bolt H
Front/Back adjust
bolt “C”
Up/down adjust
Lever B
Up/down adjust
Bolt A
Guage I
Left/Right adjust
Bolt E
5mm from Center
left/right
[Figure 1]
1) Open the Nozzle Cover - If the Bolt “H” is released in [Figure 1], The cover will be opened
2) Adjust the Nozzle (Up/Down) [Figure 2]
1. After slightly Loosening the Bolt “A”,
2. Looking the Guage of “I”
3. Adjust proper distance by turning nut lever “B”
4. After the adjustment, lock bolt “A
Front/Back adjust
Lever D
Guage “J”
Left/Right adjust
Bolt “E”
up/down
[Figure 2]
[Figure 3]
Front/Back
2~3mm
[Figure 4]
[Figure 5]
2) Adjust the Nozzle
(Front/Back) [Figure 5]
1. After slightly Loosening
the Bolt “C”,
2. Looking the Guage of “J”
3. Adjust proper distance
by turning nut lever “D”
4. After the adjustment,
lock bolt “C
4) Adjust the Nozzle of Left/Right
1. Adjust the Left/Right
by turning nut lever “E”.
2. After the adjustment, by Nut
12
[Figure 6]
Summary of Contents for HTM-3788LDi
