11
VHF 7200 US and 7200 EU Operation Manual
NAVMAN
To scan only one of your favorite channels, press 3CH then
immediately press and release SCAN. If you want to scan all three
favorite channels, press 3CH then immediately press and hold
SCAN.
To add a favorite channel for the fi rst time, select that channel then
hold 3CH to store it in the CH1 location. Repeat the procedure to
store two more favorite channels in the CH2 and CH3 locations
respectively.
If you try and add another favorite channel it will overwrite the
existing CH3. CH1 and CH2 remain unless you delete them.
To delete a favorite channel, select that channel then hold down 3CH
until the confi rmation message appears. Select YES to delete channel.
SCAN
Scan
. Press to scan between your current channel and the priority
channel in DUAL or TRI WATCH mode. The weather channel is
also scanned if the USA channel bank is selected and the weather
alert mode (ALT) is ON.
Hold down SCAN to enter ALL SCAN mode where the priority
channel is checked every 1.5 seconds.
When a signal is received, scanning stops at that channel and
BUSY appears on the screen. If the signal ceases for more than 5
seconds, the scan restarts.
Press ENT to temporarily skip over (lock out) an “always busy”
channel when in ALL SCAN mode and resume the scan. An X is
shown on the screen to designate a skipped channel. Note that it is
not possible to skip over the priority channel. Note also that SCAN
functionality is limited in some European countries.
Press SCAN to stop at the current channel.
ESC
Escape
. Use ESC when navigating menus, to clear incorrect
entries, to exit from a menu without saving changes, and to back up
to the previous screen.
WX
Weather Channel.
7200 US only.
If using US or Canadian channel
banks, press to hear the most recently selected weather station.
The WX symbol is displayed on the screen.
Press + or - or turn the rotary knob to change to a different weather
channel. Press WX again to return to the most recent channel.
If the weather alert mode (ALT) is ON and an alert tone of 1050Hz
is broadcast from the weather station, it is picked up automatically
and the alarm sounds. Press any key to cancel the alarm and to
hear the weather alert voice message.
H/L
Transmission Power
.
High (HI) 25W or Low (LO) 1W. Press
to toggle between high or low transmission power for the entire
channel bank. The HI or LO selection is shown on the screen.
Some channels allow only low power transmissions. Error beeps
will sound if the power transmission setting is incorrect.
