M-Nav 760 | User Manual
10
3 Install the M-Nav 760 in a Vehicle
Note:
These installation instructions assume that the Qube tracking device is already installed
in the vehicle and that the cable and mini-USB have been fed through the dashboard, ready for
connection to the M-Nav 760.
When you have assembled the docking cradle, use the suction cup to attach the M-Nav 760 to the
vehicle windscreen.
3.1
Assemble the Docking Cradle
You must connect the bracket to the cradle as follows:
1. Identify the two holes in the cradle and the two prongs on the bracket.
2. Slide the holes on the cradle down over the prongs on the bracket, as far as possible.
The docking cradle is assembled. You can change the tilt angle and the viewing angle with the two
adjustment knobs.
3.2 Windscreen
Installation
Note:
Some windscreens contain areas of tinted glass that may interfere with the GPS signal. Do
not mount the M-Nav 760 in these areas.
Read the Important Safety Information in section 1.1.
Decide where to locate the suction mount on the windscreen. Use the alcohol swab to thoroughly
clean that area of the windscreen, then dry the area with a soft, lint-free cloth.
Press the suction cup fi rmly against the windscreen for 3 seconds.
Push the lever down to vacuum-seal the suction cup to the windscreen.
Now you are ready to add the M-Nav 760 to the docking cradle. See section 3.3.
Two holes in the cradle
Two prongs on the bracket
Adjustment knob
for viewing angle
Adjustment knob
for tilt angle