8120
Installation and Operation Manual
51
15 User card window
A user card is an optional plug-in card that
can store data files (see section 1-3). There
are three types of files: waypoints, routes or
a track.
To go to the user card window, press
DISPLAY
,
select Other, then select User card.
4 The new file is created. Change the name
if required. The new file appears in the
file list.
Loading data from the user card to the
Instrument
This loads one file from the user card to the
Instrument:
A waypoints file: The new waypoints are
added to any existing waypoints in the
Instrument. If a new waypoint has the
same name as an existing waypoint but
has different data, the Instrument displays
both waypoints. Select:
Skip
: Do not load the new waypoint.
Replace
: Load the new waypoint and
replace the existing one.
Skip all
: Do not load any new
waypoints which have the same names
as existing waypoints.
Rplc all
: Load all new waypoints
which have the same names as existing
waypoints; the new waypoints replace
the existing waypoints.
A routes file: The new routes are added
to any existing routes in the Instrument.
If a new route has the same name as an
existing route but has different data then
the Instrument asks which route to keep.
A track file: The new track will replace the
existing track in the Instrument.
CAUTION
!
!
CAUTION
DANGER
WARNING
1 Before using a user card, remove any
chart card and plug the user card in.
When you have finished with the user
card, remove the user card and replace
the chart card (see section 1-3).
The user card window has:
File list
A list of the files on any user card in the
Instrument. If there are more files than will fit
on the window, press or to scroll up or
down a page at a time.
Waypoints, Routes
The number of waypoints and routes
currently in the Instrument.
Track 1 to Track 5
The number of points in tracks 1 to 5
currently in the Instrument.
Note:
1 To save Instrument data onto the user
card, use the Save command (see below).
2 Data stored on the user card and shown
on the file list is not available to be used
by the Instrument until loaded into the
Instrument with the LOAD command (see
below).
Saving data to the user card
This saves all the Instrument’s waypoints,
all the Instrument’s routes or one of the
Instrument’s tracks to one file on the user
card.
1 Press
MENU
and select
Save
.
2 Select
Waypts
,
Routes
or
Tracks
.
3 For
Tracks
, select the track number to
save.
