Version 16.03.2023
HW: CAM(V100)/UP(V30) right
RL4-PCM60
P
a
g
e
8
1.4.6.
Activation of the factory PDC display (Dip 8)
Dip 8 is used to switch between image formats of front and rear camera and to display the
factory PDC (if available) as „picture in picture“ in combination with the camera image.
Note: A correct display of the PDC is only possible if the PDC is by factory displayed on the
right side of the monitor.
Note: If there is no communication between interface and the vehicle`s CAN-bus (several
vehicles aren’t compatible), the optical PDC and the reverse gear guide-lines can`t be shown
during the vehicle’s operation, even if they once appear after having switched the system to
powerless!
Dip switch 4 is out of function and has to be set to OFF.
1.5.
Settings of the 4 Dip switches (CAN functions – red)
Dip position down is ON and position up is OFF.
1.6.
Settings of the 2 Dip switches (selection head-unit - black)
The 2 dip switches on the upper side of the interface box are used to select the head
unit.
Dip position up is ON and position down is OFF.
Fahrzeug/Navigation
Dip 1
Dip 2
PCM 4.1 (Harman)
ON
ON
PCM 5.0 (Alpine)
OFF
OFF
PCM 6.0 (Aptive/Delphi)
OFF
ON
After each Dip-switch-change a power-reset of the video interface has to be performed!
Dip
Funktion
ON (unten)
OFF (oben)
1
Maual selection of the
Head Unit System
(only possible
if dip2= OFF)
Harman
Alpine, Aptiv/Delphi
2
Automatic recognition of
the head unit system
enabled
disadled
(with manual selection of the
Head Unit via di1)
3
No function
Auf OFF stellen
4
No function
Auf OFF stellen
