Version 09.02.2023
HW: CAM(V100)(V20)
RL3-A15
P
a
g
e
7
2.
Installation
Switch off the ignition and disconnect the vehicle’s battery! The interface needs a
permanent 12V source. If -according to factory rules- a disconnection of the battery has to
be avoided, it should be sufficient to use the vehicle’s sleep-mode. In case, the sleep-mode
doesn’t succeed, the battery has to be disconnected with a resistor lead.
The Interface needs a permanent power supply! If power isn’t directly taken from the
battery, the connection’s power has to be checked for being start-up proven and
permanent.
2.1.
Place of installation – video-interface
The video-interface shall be installed on the backside of the head-unit.
2.2.
Place of installation – daughter PCB
The daughter PCB is performed to be installed on the rear side of the head unit’s monitor
instead of the original base plate
